Throttle Position Sensor: Service and Repair

REMOVAL
- Disconnect negative cable at battery.
- Disconnect TPS connector.

Removing Terminals:

- Pull out TPS wire harness terminals from connector after unlocking terminal lock.
- Remove TPS from throttle body.

INSTALLATION
- Install TPS to throttle body.

Installing TPS:

- Fit sensor to throttle body in such way that its adjusting holes are a little away from sensor mounting bolt holes as shown and turn sensor clockwise so that those holes align. Then hand-tighten sensor mounting bolts in aligned holes.

Inserting Terminals:

- Insert TPS terminals into connector and check to make sure that they are locked.
- Adjust installation angle of TPS.
- Connect battery negative cable to battery.