DTC 24: Shift Solenoid No. 2: Notes
NOTE:
DTC 24 will set if shift solenoid No. 2 or its circuit is shorted to ground.
- Turn ignition off. Disconnect TCM harness connectors. Using a DVOM, measure resistance between TCM harness connector terminal A14 (Green/Orange wire) and terminal A12 (Black/Red wire). If resistance is about 13 ohms, check for an intermittent problem. See DIAGNOSTIC AIDS . If resistance is not as specified, go to next step.
- Test operation of shift solenoid No. 2. See SOLENOIDS under COMPONENT TESTING. Replace if necessary. If solenoid tests okay, repair Green/Orange wire for a short to ground.