Park/Neutral Position (PNP) Switch
Ensure ignition is off. Disconnect PNP switch harness connector. Check continuity of specified circuits. Refer to the PARK/NEUTRAL POSITION (PNP) SWITCH CONTINUITY table. Make sure there is no continuity to ground or continuity to any other terminals. Refer to the appropriate wiring diagram in WIRING DIAGRAMS . Also refer to Figs. Figure and Figure . Replace switch as needed.
PARK/NEUTRAL POSITION (PNP) SWITCH CONTINUITY
| Selector Position | Terminals |
|---|---|
| "P" (Park) | 8 & 9 |
| "R" (Reverse) | 1 & 7 |
| "N" (Neutral) | 8 & 10 |
| "D" (Drive) | 2 & 8 |
| "2" (Second) | 3 & 8 |
| "1" (Low) | 4 & 8 |