Throttle Position Sensor (TPS): Notes
THROTTLE POSITION SENSOR (TPS) RESISTANCE
| Application | Ohms | |
|---|---|---|
| Between Terminals "A" & "B" | ||
| W/ .012" (.30 mm) Clearance At Stop Screw | Less Than 5000 | |
| W/ .035" (.89 mm) Clearance At Stop Screw | Infinity | |
| Between Terminals "A" & "D" | 4370-8130 | |
| Between Terminals "A" & "C" | ||
| At Idle | 240-1140 | |
| At Wide Open Throttle | 3170-6600 | |
CAUTION:
DO NOT
attempt to adjust throttle stop screw to adjust idle. Throttle stop screw is factory-set, and is used as zero reference point for all other adjustments.
CAUTION:
DO NOT
adjust SOHC throttle stop screw to adjust idle. Throttle stop screw is factory-set, and is used as zero reference point for all other adjustments.