Shift Lever Switch: Installation
- Shift selector lever to "N" position. Using flat tip screwdriver, turn shift lever switch joint clockwise or counterclockwise. See Fig 1
. Ensure a click is heard from joint at this position.
- After installing shift lever switch to manual shift shaft, move shift lever switch by hand in direction of arrow. See Fig 2
. Stop at position where a click from joint is heard or felt by hand. Tighten shift lever switch bolt to 10-17 ft. lbs. (13-23 N.m).
- Install coupler and clamp. Check for proper installation. Apply parking brake and block vehicle wheels. Check for the following:
- With selector lever in "P", turn starter switch to ON position. Engine should start.
- With selector lever in "N", turn starter switch to ON position. Engine should start.
- With selector lever shifted from "N" to "L" and back to "N", turn starter switch to ON position. Engine should start.
- Shift selector lever from "N" to "P". Check start motor for operation.
- Ensure starting motor and starter switch operate in "P" and "N" position.
- Without starting engine, turn ignition switch to ON position and shift selector lever to "R". Ensure back-up lights illuminate.
Courtesy of SUZUKI OF AMERICA CORP.
Courtesy of SUZUKI OF AMERICA CORP.