Transfer Case
WARNING: This page is about a different car, the 1994 Geo Tracker and 1993 Geo Tracker. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support vehicle. Remove drain plug from back of transfer case, below speedometer gear housing, and drain fluid. Install drain plug. Tighten it to 21 ft. lbs. (28 N.m).
- Remove transfer case fill plug (upper plug) from rear of transfer case. Fill plug is located near speedometer gear housing.
- Fill transfer case with SAE 75W-90 or 80W-90 gear oil with GL-4 rating until fluid level is at bottom of fill plug hole. Install fill plug, and tighten it to 21 ft. lbs. (28 N.m).