LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1994 >> Samurai >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Tire Pressure Monitoring System) >> Repair Instructions >> Tire Pressure Sensor Grommet Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean any dirt or debris from the grommet sealing areas.
  2. Install the grommet on the sensor valve stem.
    Fig 1: Positions For Inserting Tire Pressure Sensor
    G04843300Courtesy of SUZUKI OF AMERICA CORP.
  3. Insert the sensor in the wheel hole with the air passage facing away from the wheel.
    CAUTION: Refer to FASTENER NOTICE .
  4. Install the sensor nut and position the sensor body parallel to the inside wheel surface while torquing.

    Tightening torque 

    Tighten the sensor nut to 7 N.m (62 lb in)  .

    NOTE: Before installing the tire on the wheel, note the following items to avoid tire pressure sensor damage upon tire mounting:
    • Position the mounting/dismounting head 180 degrees from the valve stem.
    • Position the bead transition area 45 degrees counterclockwise of the valve stem.
    • Using the tire machine, rotate the tire/wheel assembly clockwise when transferring the tire bead to the inside of the wheel rim.
    • Repeat items for outer bead.
  5. Install the tire on the wheel. Refer to TIRE MOUNTING AND DISMOUNTING .
  6. Install the tire/wheel assembly on the vehicle. Refer to INSTALLATION PROCEDURE .
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals