LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1994 >> Samurai >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls - System/Component Tests - 1.3L TBI >> Engine Sensors & Switches >> Throttle Position (TP) Sensor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Throttle Position (TP) Sensor

  1. Disconnect negative battery cable and TP sensor connector. See Fig 1 . Using ohmmeter, check resistance between indicated terminals. See THROTTLE POSITION (TP) SENSOR RESISTANCE  table. If resistance is not as specified, adjust TP sensor.
  2. See ADJUSTMENTS article in this section. If resistance is not as specified after adjustment, replace TP sensor. For further diagnostic procedures, see appropriate TESTS W/CODES - 1.3L TBI article in this section.
THROTTLE POSITION (TP) SENSOR RESISTANCE

Application Ohms
Between Terminals "C" & "D"
With .008" (.02 mm) Clearance At Stop Screw 0-550
With .016" (.41 mm) Clearance At Stop Screw Infinity
Between Terminals "A" & "D" 3500-6500
Between Terminals "C" & "D"
At Idle (1) 0-2000
At Wide Open Throttle (2) 2000-6500
(1) To obtain idle position, apply 19 in. Hg vacuum to throttle opener.
(2) There should be more than 2000 ohms difference between idle and wide open throttle readings.
Fig 1: Identifying Throttle Position Sensor Connector Terminals
G93G81097Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals