Draining & Refilling: Tracker
WARNING: This page is about a different car, the 1994 Geo Tracker and 1993 Geo Tracker. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support vehicle. Place a match marks on drive shaft and flange and disconnect front drive shaft from front differential flange. Remove all transmission fluid pan bolts except 3 bolts on rear of fluid pan. Loosen remaining 3 bolts, allowing pan to tip downward so fluid will drain. Once fluid is drained, remove remaining fluid pan bolts, fluid pan and gasket. Remove filter screen and gasket.
- Install cleaned filter screen and NEW gasket. Tighten filter screen bolts to 14 ft. lbs. (19 N.m.). Install fluid pan using NEW gasket. Tighten fluid pan bolts to 10 ft. lbs. (14 N.m). Install drive shaft, and tighten drive shaft flange bolts to 37 ft. lbs. (51 N.m). Fill transmission with 1.6 qts. (1.5L) of Dexron-IIE, and check fluid level.