Throttle Position Sensor: Service and Repair

REMOVAL
1. Disconnect battery negative cable at battery.

2. Remove air cleaner assembly referring to section 6A1.

3. Disconnect coupler from TPS.

4. Remove TPS from throttle body.

Installing Throttle Position Sensor:

INSTALLATION
1. Install TPS to throttle body.

Fit TPS to throttle body in such way that its adjusting holes are a little away from TPS screw holes as shown and turn TPS clockwise so that those holes align. Then hand-tighten TPS screws.

2. Adjust installation angle of TPS.

3. Connect coupler to TPS securely.

4. Install air cleaner assembly.

5. Connect battery negative cable to battery.