Throttle Switch Inspection (SOHC M/T)
Unplug Throttle Switch (TS) connector. Using ohmmeter, check continuity between terminals of TS connector with proper shim thickness gauge inserted between throttle valve lever and stop screw. See THROTTLE SWITCH CONTINUITY table. See Figure and Fig 1 .
THROTTLE SWITCH CONTINUITY
| Application | Specification | |
|---|---|---|
| Between Terminals "A" & "B" | ||
| With .012" (.30 mm) Clearance At Stop Screw | Continuity | |
| With .035" (.89 mm) Clearance At Stop Screw | No Continuity | |
| With Throttle Wide Open | No Continuity | |
| Between Terminals "B" & "C" | ||
| With .012" (.30 mm) Clearance At Stop Screw | No Continuity | |
| With .035" (.89 mm) Clearance At Stop Screw | No Continuity | |
| With Throttle Wide Open | Continuity | |
| Between Terminals "A" & "C" | ||
| With .012" (.30 mm) Clearance At Stop Screw | No Continuity | |
| With .035" (.89 mm) Clearance At Stop Screw | No Continuity | |
| With Throttle Wide Open | No Continuity | |