LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1992 >> Swift GA, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (1.0L 3-CYL - VIN [5]) >> Removal & Installation >> Engine >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation: Engine: Removal

WARNING: This page is about a different car, the 1986 Chevrolet Sprint. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect battery cables. Remove battery, battery tray and hood. Remove air cleaner. Drain coolant and remove radiator hoses. Disconnect cooling fan wires.
  2. Remove radiator and cooling fan as an assembly. Disconnect fuel lines and heater hoses. Identify, mark and remove vacuum lines at engine. Disconnect accelerator cable at carburetor. Remove fresh air duct.
  3. Disconnect speedometer and clutch cable with bracket at transmission. Label and disconnect engine and transmission wiring. Loosen A/C compressor adjusting bolt. Remove drive belt splash shield. Raise vehicle and disconnect exhaust pipe at manifold.
  4. Loosen A/C compressor pivot bolt. Remove drive belt and A/C compressor mounting bracket. Disconnect gearshift control shaft and gearshift extension rod at transmission. Drain transmission and engine oil. Disconnect ball joints and drive axles.
  5. Remove engine torque rods and transmission mount nut. Lower vehicle and remove engine side mount and mount nuts. Install chain hoist and remove engine and transmission as an assembly.
scientia non olet · About LEMON Manuals