Throttle Valve Cable: Swift
- Ensure accelerator cable is adjusted correctly. Accelerator cable should not have any end play at throttle body with accelerator at idle position and engine off.
- Warm engine to normal operating temperature. Throttle valve must be in idle position. Remove oil pressure cable cover. Check boot-to-inner cable stopper clearance. See Fig 1
.
- If clearance is greater than .02" (.5 mm), loosen upper lock nuts and adjust cable length. If necessary, use lower lock nuts to change cable length. See Fig 1
. Tighten all lock nuts.
Courtesy of SUZUKI OF AMERICA CORP.