Removal & Installation (PFI)
- Disconnect negative battery cable. Drain engine coolant so level is below throttle body. Disconnect accelerator cable from throttle lever and cable bracket.
- Disconnect airflow meter outlet hose. Disconnect throttle position sensor connector. Label and disconnect all vacuum hoses from throttle body. Disconnect engine coolant hoses from throttle body. Remove throttle body from intake manifold.
- To install, reverse removal procedure. Using new gasket, install throttle body on intake manifold. Tighten throttle body mounting bolts and nuts to 13-20 ft. lbs. (18-27 N.m). After installing accelerator cable, ensure cable has .12-.20" (3.0-5.0 mm) play.
- Hold exposed portion of cable at center and move cable up and down to measure play. See Fig 1
. Use lock nuts on cable bracket to adjust play. Refill cooling system.
Courtesy of SUZUKI OF AMERICA CORP.