Throttle Switch (M/T Only)

1. Disconnect negative cable at battery.

2. Remove air cleaner assembly.

3. Disconnect connector from TS.

Inserting Thickness Gauge:

4. Insert thickness gauge between throttle stop screw and throttle lever.

Checking Throttle Switch:

Throttle Switch Specifications:

3. Using ohmmeter, check continuity between terminals under each condition given in table.

If check result is not satisfactory, replace TS. However, if only idle switch check is not satisfactory adjust installation angle of TS and recheck.


6. Connect TS coupler securely.

7. Install air cleaner assembly.

8. Connect battery negative cable to battery.