Throttle Switch (Swift SOHC With M/T)
- Disconnect negative battery cable. Disconnect throttle switch connector. See Fig 1 . Using an ohmmeter, check continuity between indicated terminals. See THROTTLE SWITCH CONTINUITY table.
- If resistance is not as specified, adjust throttle switch. See ADJUSTMENTS article in the ENGINE PERFORMANCE Section. If resistance is not as specified after adjustment, replace throttle switch.
THROTTLE SWITCH CONTINUITY
| Application | Specification | ||
|---|---|---|---|
| Swift SOHC With M/T | |||
| Between Terminals "A" & "B" | |||
| With .012" (.30 mm) Clearance At Stop Screw | Continuity | ||
| With .035" (.89 mm) Clearance At Stop Screw | No Continuity | ||
| With Throttle Wide Open | No Continuity | ||
| Between Terminals "B" & "C" | |||
| With .012" (.30 mm) Clearance At Stop Screw | No Continuity | ||
| With .035" (.89 mm) Clearance At Stop Screw | No Continuity | ||
| With Throttle Wide Open | Continuity | ||
| Between Terminals "A" & "C" | |||
| With .012" (.30 mm) Clearance At Stop Screw | No Continuity | ||
| With .035" (.89 mm) Clearance At Stop Screw | No Continuity | ||
| With Throttle Wide Open | No Continuity | ||