Swift DOHC
- Idle speed is controlled by the ISC solenoid valve and should not require adjustment. If idle speed needs to be changed, start and warm engine to operating temperature and turn all accessories off. Ensure all fuel and emission control system wire connectors and hoses are properly connected. Ensure accelerator cable has free-play. Ensure air cleaner and ducting are properly installed and air filter element is in good condition.
- Ensure ignition timing is correct. See IGNITION TIMING
table. Install spare fuse in diagnosis terminal in fuse box (CHECK ENGINE should indicate Code 12). Attach tachometer to negative coil terminal (Brown/White wire) using adapter or attach an inductive pick-up type tachometer. Remove idle speed adjustment screw protective cap from top of throttle body. See Figure
. Turn idle speed adjustment screw to obtain correct idle RPM. See IDLE SPEED SPECIFICATIONS (PFI)
table.
- On vehicles equipped with A/C, turn A/C switch on and set fan switch to LOW position. With A/C operating correctly, verify idle is 850-950 RPM. If adjustment is required, turn A/C Vacuum Solenoid Valve (VSV) adjustment screw to obtain correct idle. Refer to the IDLE SPEED SPECIFICATIONS (PFI)
table.
- Reinstall protective cap to throttle body and remove spare fuse from diagnosis terminal.
IDLE SPEED SPECIFICATIONS (PFI)
| Application |
Idle RPM |
| Swift DOHC |
| With A/C Off |
800-900 |
| With A/C On |
850-950 |