Coil Spring: Removal
- Raise and support vehicle. Remove front wheel(s). On 2WD models, remove hub center cover. On 4WD models, remove free-wheeling hub. See FREE-WHEELING HUB (4WD) under REMOVAL & INSTALLATION. Remove axle shaft snap ring. On all models, disconnect brake line from strut. Remove caliper from steering knuckle, and wire aside. Remove tie rod end from steering knuckle using Tie Rod Remover (09913-65210). Remove stabilizer ball joint.
- Remove brake disc. If disc cannot be remove by hand, install (2) 8 mm bolts into threaded holes. Alternately tighten bolts to remove rotor from hub. Support control arm with jack. Remove strut-to-steering knuckle bolts. Disconnect ball joint from steering knuckle. Remove steering knuckle from vehicle. Slowly lower jack supporting control arm and remove coil spring from stubber.