Flow Test
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If the flow rate is less than 0.5 gpm, the LCD displays an error message. Refer to the Troubleshooting section of the operation manual.
- Turn the main function switch to the FLOW position and allow the oil to flow for 15 seconds. Observe and note the flow rate; this is the TESTED flow rate.
- Compare the TESTED flow rate to the MINIMUM flow rate information previously recorded.
- If the TESTED flow rate is equal to or greater than the MINIMUM flow rate recorded, the oil cooling system is functioning properly. Perform CODE RECORDING PROCEDURE .
- If the TESTED flow rate is less than the MINIMUM flow rate previously recorded, repeat the back flush and forward flush procedures.
- If the TESTED flow rate is less than the MINIMUM flow rate after the second test, perform CODE RECORDING PROCEDURE .
- Replace the transmission oil cooler.
- Reconnect supply and waste hoses to the cooler lines in the normal flow direction. Perform FLOW TEST .
- Perform CODE RECORDING PROCEDURE .