Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Knock Sensor & Bolt (2 Of 2)

Courtesy of SUZUKI OF AMERICA CORP.

CAUTION: Refer to FASTENER NOTICE .

Position the knock sensor and tighten the knock sensor bolt.
Tightening torque

Tighten the bolt to 23 N.m (17 lb ft) .

Fig 2: Connecting Engine Wiring Harness Electrical Connector To Bank 1 Knock Sensor
Courtesy of SUZUKI OF AMERICA CORP.
Connect the engine wiring harness electrical connector (2) to the bank 1 knock sensor.

Fig 3: Installing Rear Exhaust Manifold Heat Shield
Courtesy of SUZUKI OF AMERICA CORP.
Position the rear exhaust manifold heat shield to the engine and install the bolts.
Tightening torque

Tighten the bolts to 50 N.m (37 lb ft) .
Install the right catalytic converter. Refer to INSTALLATION PROCEDURE .
Lower the vehicle.