LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1991 >> Samurai JS >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Engine Mechanical) >> Repair Instructions >> Valve Stem Oil Seal and Valve Spring Replacement - Left Side >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Valve Stem Seal (2 Of 2)
G04841576Courtesy of SUZUKI OF AMERICA CORP.
  1. Use the EN 46116 (1) in order to install the valve stem seal (2).
    Fig 2: Identifying Valve Spring
    G04841577Courtesy of SUZUKI OF AMERICA CORP.
  2. Install the valve spring.
  3. Install the valve spring retainer.
    Fig 3: Identifying Valve Spring Compressor Nut
    G04841578Courtesy of SUZUKI OF AMERICA CORP.
  4. Install the EN 46110 above the applicable valve spring as shown.

    Tighten the EN 46110 valve spring compressor nut (2).

    Fig 4: Identifying Valve Spring Keepers
    G04841579Courtesy of SUZUKI OF AMERICA CORP.
  5. Install the valve spring keepers.
  6. Remove the EN 46110.
  7. Disconnect the J 39313 from the compressed air source.
  8. Remove the J 39313.
  9. Install the spark plugs. Refer to INSTALLATION PROCEDURE .
  10. Install the rocker arms and camshafts. Refer to INSTALLATION PROCEDURE .
  11. Remove the EN 46106 in order to prevent crankshaft rotation.
  12. Install the starter motor. Refer to INSTALLATION PROCEDURE .
scientia non olet · About LEMON Manuals