LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1991 >> Samurai JS >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Engine Mechanical) >> Repair Instructions >> Crankshaft Balancer Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine support fixture. Refer to INSTALLATION PROCEDURE .
  2. Remove the engine mount strut bracket. Refer to REMOVAL PROCEDURE .
  3. Remove the engine mount. Refer to REMOVAL PROCEDURE .
  4. Remove the starter. Refer to STARTER REMOVAL .
    Fig 1: Installing EN 46106 Through Starter Mounting Hole
    G04841465Courtesy of SUZUKI OF AMERICA CORP.
  5. Install the EN 46106 through the starter mounting hole.
    Fig 2: Identifying Crankshaft Balancer Bolt
    G04841466Courtesy of SUZUKI OF AMERICA CORP.
  6. Using engine support fixture, lower engine approximately two inches.
  7. Remove the crankshaft balancer bolt.
    Fig 3: Identifying Special Tool (J 41816)
    G04841467Courtesy of SUZUKI OF AMERICA CORP.
  8. Install the J 38416-2 in the nose of the crankshaft.
  9. Install the J 41816 in order to remove the crankshaft balancer.
  10. Tighten the center bolt of the J 41816 in order to pull the crankshaft balancer off of the crankshaft.
  11. Remove the J 41816 from the crankshaft balancer.
scientia non olet · About LEMON Manuals