Camshaft Position Actuator Installation - Right Side Intake (Fourth Design)

Reference: CAMSHAFT TIMING DRIVE COMPONENTS CLEANING AND INSPECTION (FOURTH DESIGN) .

Fig 1: Identifying Camshaft Position Actuator

Courtesy of SUZUKI OF AMERICA CORP.

1. Ensure the proper camshaft position actuator is installed. Observe the body of the camshaft position actuator for the "IN" marking (3). The marking is for an intake camshaft position actuator.
   Fig 2: Identifying Left & Right Intake Camshaft Position Actuator

   Courtesy of SUZUKI OF AMERICA CORP.
   CAUTION: Ensure the proper camshaft position actuator is installed in the correct position. Failure to install the proper camshaft position actuator can effect engine performance and set an engine code.
2. Ensure the proper camshaft position actuator is being installed. The reluctor wheel on the 4th design right intake camshaft position actuator (1) is indexed in a different position compared to the 4th design left intake camshaft position actuator (2).
   Fig 3: Identifying Intake Camshaft Actuator Edge Of Reluctor Wheel

   Courtesy of SUZUKI OF AMERICA CORP.
3. On the right intake camshaft actuator the edge of the reluctor wheel (1) lines up with the valley (2) of the sprocket tooth.
   Fig 4: Identifying Timing Mark

   Courtesy of SUZUKI OF AMERICA CORP.
4. Ensure the proper timing mark is used. Observe the outer ring of the camshaft position actuator for the triangle marking (2). The triangle marking is for alignment to the highlighted timing chain link on the right side of the engine.
   CAUTION: Refer to TORQUE REACTION AGAINST TIMING DRIVE CHAIN NOTICE .
5. Use an open wrench on the hex cast into the camshaft in order to prevent camshaft rotation when tightening the camshaft position actuator bolt.
   Fig 5: Identifying Right Intake Camshaft Position Actuator & Bolt

   Courtesy of SUZUKI OF AMERICA CORP.
6. Install the right intake camshaft position actuator.
   CAUTION: Refer to FASTENER NOTICE .
7. Install the camshaft position actuator bolt.

   Tightening torque 

   Tighten the camshaft position actuator bolt to 58 N.m (43 lb ft)  .

   Reference: CAMSHAFT POSITION ACTUATOR INSTALLATION - RIGHT SIDE EXHAUST (FOURTH DESIGN) .