Conditions for Setting the DTC

All of the following conditions must exist for 5 seconds:

B0081 0F 

• The SDM has received a fault present message from the PPS.
• The PPS is in assembly plant mode and the SDM is in production mode.
• After the PPS change states, the SDM signal stating the Passenger Status Data Received is not valid within 2.6 seconds.

  B0081 3A 

• The SDM has received an ID message from the PPS which does not match the ID stored in the SDM memory.
• The SDM has reset the PPS twice without detecting the correct ID message.

  B0081 39 

• The SDM has received a NOK message from the PPS.
• The SDM has not received a message.

B0081 71 

The SDM has received invalid serial data from the PPS.