LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1991 >> Samurai JS >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Air Bag System) >> Diagnostic Information and Procedures >> DTC B0012 or B0013 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When removing connectors inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected component/connector.
  • The pretensioner
  • The air bag module
  • The SDM module
  • The air bag wiring harness connector
  • The SDM wiring harness connector
  1. Verify that the steering wheel module connector and the connector position assurance (CPA) are engaged.
    NOTE: The connector and CPA may seat independent of each other. Both the connector and CPA should seat with an audible and/or tactile click. The CPA isolates the shorting-bars within the connector allowing the deployment circuit to operate properly.
    • If the above condition is found, make the appropriate repair.
  2. Ignition OFF, disconnect the steering wheel module.
  3. With the applicable adaptor, connect special tool J 38715-A.
  4. Ignition ON, with a scan tool, verify DTC is set as current.
    • If DTC is not set or is set as history, replace the steering wheel module.
  5. Ignition OFF, disconnect special tool J 38715-A.
  6. Disconnect the steering wheel module coil in-line connector.
  7. With the applicable adaptor, connect special tool J 38715-A.
  8. Ignition ON, with a scan tool, verify DTC is set as current.
    • If DTC is not set or is set as history, replace the steering wheel module coil.
  9. Ignition OFF, disconnect special tool J 38715-A and the applicable adaptor.
  10. Ignition ON, test for less than 1 volt between the applicable HI circuit and ground.
    • If not the specified range, test the circuit for a short to voltage.
  11. Test for less than 1 volt between the applicable LOW circuit and ground.
    • If not the specified range, test the circuit for a short to voltage.
  12. Ignition OFF, test for infinite resistance between the applicable HI circuit and ground.
    • If not the specified range, test the circuit for a short to ground.
  13. Test for infinite resistance between the applicable LOW circuit and ground.
    • If not the specified range, test the circuit for a short to ground.
  14. Disconnect the harness connector at the SDM.
  15. Test for less then 1 Ω of resistance between the SDM connector and the air bag module connector HI circuit.
    • If not the specified range, test the circuit for an open/high resistance.
  16. Test for less then 1 ohm of resistance between the SDM connector and the air bag module connector LOW circuit.
    • If not the specified range, test the circuit for an open/high resistance.
  17. If all circuits test normal, replace the SDM.
scientia non olet · About LEMON Manuals