Select Cable: Installation
- To install select cable, reverse removal procedure. Apply grease to pin and cable joint.
- Before tightening cable end nut, shift selector lever and manual shift lever to "N" position.NOTE: Ensure nut and cable joint have clearance.
- Turn nut "A" by hand until nut contacts manual select cable joint. See Fig 1
. Tighten nut "B" with wrench. After select cable is installed, check for following:
- Push vehicle with selector lever shifted to "P". Vehicle should not move.
- Vehicle can not be driven in "N".
- Vehicle can be driven in "D", "2" and "L".
- Vehicle can be backed up in "R".