LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1990 >> Swift GA, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (1.0L 3-CYL - VIN [M]) >> Removal & Installation >> Valve Guide Servicing >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Valve Guide Servicing: Installation

WARNING: This page is about a different car, the 1985 Chevrolet Sprint. However, it is still accessible from the selected car via links, so may be relevant.
  1. Prior to valve guide installation, ream guide hole with Reamer (J-34832) or a 12 mm reamer, to remove burrs. Ensure diameter of hole is within specification.
  2. Heat cylinder head to 176-212°F (80-100°C) and drive valve guide into hole using Valve Guide Remover/Installer (J-34834). Drive guide until installer contacts cylinder head. After installation, top of guide should measure 14 mm from surface of cylinder head.
  3. Ream valve guide bore with Reamer (J-34831) or a 7 mm reamer. After reaming, clean bore. Install valve spring seat to cylinder head. By hand, install new oil seal using Oil Seal Installer (J-34835). Ensure seal is properly seated. To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals