Starter - Gt (M/T): Overhaul: Reassembly
NOTE:
Install O rings without fail. When assembling motor parts, make sure that locators are properly aligned with each other.
- Lubricate all surfaces as shown in Fig 1. Install overrunning clutch, stop ring, note direction of stop ring. See Fig 2.
- Install shaft assembly into front housing. Making sure that the internal gear housing is aligned so that the holes for the through bolts line up. If the center bearing and shock assembly has been disassembled, see Fig 3 for reassembly. See Figure for disassembly.
- Fit armature and yoke together then fit the assembly to the front housing, being sure to align match marks on the yoke that were made prior to disassembly.
- Apply grease as shown in Fig 1. Mount brush holder, install assembly over commutator. Install and tighten through bolts
- Install and tighten 2 solenoid to drive housing screws. Install starter housing field coil lead to solenoid terminal and tighten retaining nut.