Component Disassembly & Reassembly: Governor: Inspection

WARNING: This page does not describe the selected car, but rather 124 other vehicles, including the 1991 Chevrolet Pickup, 1991 Chevrolet Cab & Chassis, 1988 GMC Vandura Special, 1988 GMC Vandura, and 1988 GMC Value Van. However, it is still accessible from the selected car via links, so may be relevant.

Wash all parts in solvent and air dry. Blow out all passages. Inspect sleeve for wear or damage. Check for free operation in case bore. Check driven gear for looseness on sleeve.
Ensure valve opening at entry and exhaust is .020" (.51 mm) minimum. Valve opening measurements are made with driven gear up and thrust cap down. Entry measurement is made with weights extended while exhaust is measured with weights inward.