LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1990 >> Sidekick JS >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Overhaul - THM 400) >> Component Disassembly & Reassembly >> Governor >> Driven Gear Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Driven Gear Replacement

WARNING: This page does not describe the selected car, but rather 124 other vehicles, including the 1991 Chevrolet Pickup, 1991 Chevrolet Cab & Chassis, 1988 GMC Vandura Special, 1988 GMC Vandura, and 1988 GMC Value Van. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drive out gear retaining split pin. Support assembly on 3/16" plates installed in exhaust slots of sleeve. Using a press, press gear out of sleeve with long punch. Clean governor sleeve of chips.
  2. To install new gear, press gear into sleeve until nearly seated. Remove any chips that may have been shaved off gear. Press gear in until bottomed on shoulder.
  3. New pin hole must be drilled through sleeve and gear. Support governor in press. Locate hole position 90 degrees from existing hole. Center punch and drill new hole through sleeve and gear with 1/8" drill bit. Install new pin.
scientia non olet · About LEMON Manuals