April 5, 2026: LEMON Manuals is launched! Read the announcement.

Rear Wheel Drive Module Clutch Housing Replacement

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Electrical Clutch Control

G04843787

Courtesy of SUZUKI OF AMERICA CORP.

PROCEDURE TABLE

Callout	Component Name
Preliminary Procedure Raise the vehicle. Refer to LIFTING AND JACKING THE VEHICLE . Remove the propeller shaft from the differential clutch drum assembly. Refer to REMOVAL PROCEDURE .
1	Connector, Electrical Clutch Control.
2	Clip, Retaining (Qty: 2)
3	Bolts, Differential Clutch Drum (Qty: 4). CAUTION: Refer to FASTENER NOTICE . Tightening torque Tighten bolts to 29 N.m (21 lb ft). Tip: Relocate the rear portion of the propeller shaft to the side and support it with mechanics wire or equivalent.
4	Drum, Differential Clutch. Procedure Rear Differential Clutch Control Module Recalibration. Refer to REAR DIFFERENTIAL CLUTCH CONTROL MODULE CALIBRATION . Tip: The pinion flange, dust cover and pinion nut are serviced with the differential clutch drum assembly.
5	Gasket, Differential Clutch Drum. Tip: Apply a small amount of grease to the gasket to hold it in place