TPS Adjustment

With negative battery cable and TPS connector disengaged, loosen TPS attaching screws. Place a .025" (.65 mm) thickness gauge between adjustment screw and stop lever.
Connect ohmmeter between terminals "C" and "D". See Fig 1 . Slowly rotate TPS to locate the position that ohmmeter changes from zero continuity to infinity. With TPS sensor in this position, tighten attaching screws to 30 inch lbs. (3.4 N.m) and repeat inspection procedure to verify correct operation.

THROTTLE POSITION SENSOR (TPS) RESISTANCE

Application & Condition

Ohms

Between Terminals C-D

.012" (.3 mm) ⁽¹⁾

0-500

.035" (.9 mm) ⁽¹⁾

Infinite

Between Terminals A-C

3500-6500

Between Terminals B-C

At Idle

0-500

Wide Open Throttle

3500-6500

⁽¹⁾	Selected thickness gauge between throttle stop screw and stop lever.

Fig 1: Swift Throttle Position Sensor (TPS) Terminal ID

Courtesy of SUZUKI OF AMERICA CORP.