PTC (Mixture) Heater Relay
- Turn igniton off. Disconnect PTC heater relay. Relay is located in engine compartment near right shock tower. Start engine. With engine idling, battery voltage should be present on White/Black wire from main fuse and on Light Green/Red wire from control relay terminal "E". Correct as necessary.
- Turn ignition off. Using an ohmmeter, measure resistance across White/Greeen wire terminal of relay and Light Green/Red wire terminal of relay. Continuity should exist. If not replace relay.
- Energize relay by applying battery voltage to Light Green/Red wire terminal of relay and ground to White/Green wire terminal of relay. Using an ohmmeter, measure resistance across White/Black wire terminal of relay and White wire terminal of relay. Continuity should exist only while relay is energized. If relay does not function as described, replace relay.