LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1988 >> Samurai Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Engine Mechanical) >> Repair Instructions >> Engine Mount Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Engine Mount Inspection

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Before replacing any engine mount due to suspected fluid loss, verify that the source of the fluid is the engine mount, not the engine or accessories.
  1. Install the engine support fixture. Refer to INSTALLATION PROCEDURE .
  2. Observe the engine mount while raising the engine. Raising the engine removes the weight from the engine mount and creates slight tension on the rubber.
  3. Replace the engine mount if the engine mount exhibits any of the following conditions:
    • The hard rubber is covered with heat check cracks.
    • The rubber is separated from the metal plate of the engine mount.
    • The rubber is split through the center of the engine mount.
    • The engine mount itself is leaking fluid.
  4. For engine mount replacement. Refer to ENGINE MOUNT REPLACEMENT - RIGHT SIDE , TRANSMISSION REAR MOUNT REPLACEMENT (GETRAG 760 TRANSFER CASE) , TRANSMISSION FRONT MOUNT REPLACEMENT or TRANSMISSION MOUNT REPLACEMENT - LEFT SIDE .
scientia non olet · About LEMON Manuals