LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1988 >> Samurai Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Engine Mechanical) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Air Cleaner Assembly (2 Of 2)
G04841406Courtesy of SUZUKI OF AMERICA CORP.
  1. If the air cleaner assembly was replaced, install the MAF/IAT sensor. Refer to INSTALLATION PROCEDURE .
  2. Install the air cleaner assembly by inserting the two pins into the front panel.
    CAUTION: Refer to FASTENER NOTICE .
  3. Install the air cleaner bolt.

    Tightening torque 

    Tighten the bolt to 10 N.m (89 lb in)  .

    Fig 2: Connecting Engine Wiring Harness Electrical Connector
    G04841407Courtesy of SUZUKI OF AMERICA CORP.
  4. Connect the engine wiring harness electrical connector to the MAF/IAT sensor.
  5. Install the air cleaner outlet duct. Refer to INSTALLATION PROCEDURE .
scientia non olet · About LEMON Manuals