Alternator & Regulator - NIPPONDENSO: Overhaul: Disassembly
- Remove "B terminal retaining nut. Remove "B" terminal insulator. Remove 3 rear cover retaining nuts. Take off rear cover. Loosen and remove 2 regulator mounting screws and 3 brush holder screws. Remove regulator and brush holder.
- Remove 4 stator coil terminal retaining screws. Remove rectifier holder with I.C. regulator. Loosen and remove 4 rear end frame retaining nuts. Loosen alternator pulley retaining nut.
- Pull off alternator pulley. Using plastic mallet, lightly tap rotor from drive end frame. Remove 4 front end bearing retaining screws and front end bearing (if necessary).
- Using a bearing puller, pull off rear bearing from rotor (if necessary).