ID Registration With Suzuki Scan Tool

Confirm that ignition mode of keyless push start system is OFF
Connect Suzuki scan tool to data link connector (DLC).
Push engine switch to change ignition mode to ON.
Select "TPS ID registration" of "Utility" under "keyless start control module" mode of Suzuki scan tool.
Using recommended tool VT55 at tire pressure sensor, activate each sensor according to the instructions displayed on Suzuki scan tool, within 180 seconds.
When tire pressure sensor is activated, ID code of tire pressure sensor is registered automatically in keyless start control module. When "ID code registration status" indicated on Suzuki scan tool is "Complete", registration has been completed. If "Time Out" is indicated, perform all the registration procedures again. Also, it is possible to check the number of ID codes of tire pressure sensors received by keyless start control module by observing the flashing pattern of low tire pressure warning light
NOTE: When registering tire pressure sensor ID codes using Suzuki scan tool, former ID codes are cleared. Therefore, if registration is not completed, perform the above steps again.

NOTE: When keyless start control module receives each ID code of 4 tire pressure sensors, keyless start control module turns ON low tire pressure warning light in combination meter for 5 seconds.
Push engine switch to change ignition mode to OFF and disconnect Suzuki scan tool from DLC.