Ignition Lock Cylinder Case Replacement

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Ignition Lock Cylinder Case & Bolt

Courtesy of SUZUKI OF AMERICA CORP.

CALLOUT COMPONENT NAME

Callout	Component Name
Preliminary Procedure Remove the multifunction turn signal switch housing. Refer to MULTIFUNCTION TURN SIGNAL SWITCH HOUSING REPLACEMENT .
1	Ignition Lock Cylinder Case Bolt CAUTION: Refer to FASTENER NOTICE . Procedure Use a small chisel and hammer to back out the ignition lock cylinder case bolt counterclockwise and remove it. When installing a new ignition lock cylinder case bolt continue to tighten it until the head shears off.
2	Ignition Lock Cylinder Case Strap
3	Ignition Lock Cylinder Case Procedure Disconnect any electrical connectors as needed. Tip: The ignition lock cylinder must be turned to the run position in order to remove and/or install the ignition lock cylinder case.