LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1987 >> Samurai Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Power Assisted Steering System) >> Repair Instructions >> Steering Gear Inner Tie Rod Replacement - Off Vehicle >> Assembly Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Assembly Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Retaining Washer & Steering Linkage Inner Tie Rod Housing (2 Of 2)
G04844046Courtesy of SUZUKI OF AMERICA CORP.
  1. Position the NEW retaining washer (1).
  2. Attach the steering linkage inner tie rod onto the rack.
    CAUTION:

    Refer to PIPE WRENCH POSITIONING NOTICE .

  3. Place a pipe wrench on the rack next to the steering linkage inner tie rod housing (2).
    CAUTION:

    Refer to FASTENER NOTICE .

  4. Place a torque wrench and OTC 09922-10010-01 Inner Tie Rod Wrench on the flats of the steering linkage inner tie rod housing (2).

    Tightening torque 

    Tighten to 78 N.m (58 lb ft). 

  5. Bend the tabs over on the retaining washer (1) to secure it.
  6. Install the steering gear boot. Refer to INSTALLATION PROCEDURE .
scientia non olet · About LEMON Manuals