Valve Rocker Arm Installation - Left Side

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Reference: VALVE ROCKER ARMS CLEANING AND INSPECTION .

Fig 1: Identifying Camshaft Followers (1 Of 2)

Courtesy of SUZUKI OF AMERICA CORP.

Apply a liberal amount of lubricant GM P/N 12345501 (Canadian P/N 992704) or equivalent to the pivot pocket (1), roller (2) and valve slot (3) areas of the camshaft followers.

Fig 2: Identifying Camshaft Followers (2 Of 2)
Courtesy of SUZUKI OF AMERICA CORP.

NOTE: The follower must be positioned squarely on the valve tip so that the full width of the roller will completely contact the camshaft lobe. If the followers are being reused you must put them back in their original location.
Place the camshaft followers in position on the valve tip and stationary hydraulic lash adjuster (SHLA).
The rounded head end of the follower goes on the SHLA while the flat end goes on the valve tip.
Clean the camshaft journals and carriers with a clean, lint-free cloth.
Reference: CAMSHAFT INSTALLATION - LEFT SIDE .