Disassembly Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Positioning Wheel Drive Shaft Bar In Soft Jawed Vise

Courtesy of SUZUKI OF AMERICA CORP.

Position wheel drive shaft bar in a soft jawed vise and clamp securely.
Using side cutters, remove and discard the small seal clamp.

Fig 2: Removing Large Seal Retaining Clamp
Courtesy of SUZUKI OF AMERICA CORP.
Remove large seal retaining clamp using a flat-bladed tool and discard the clamp.

Fig 3: Separating Seal From Tripot Housing At Large Diameter
Courtesy of SUZUKI OF AMERICA CORP.
Separate the seal from the tripot housing at the large diameter and slide the seal away from the joint along the axle shaft.
Wipe the excess grease from the face of the tripot spider and the inside of the tripot housing.
Remove the tripot housing from the spider and shaft.

Fig 4: Identifying Retaining Ring Grove
Courtesy of SUZUKI OF AMERICA CORP.
Remove the retaining ring from the groove on the wheel drive shaft bar and remove the spider assembly.
Remove the seal from the wheel drive shaft bar.
Thoroughly clean all parts with a suitable solvent, removing all traces of grease and contaminants.
Dry all parts with compressed air.
Inspect the tripot joint components for unusual wear, cracks, and other damage. Replace any damaged components.