LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1987 >> Samurai Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Propeller Shaft) >> Diagnostic Information and Procedures >> Pinion Flange Runout Measurement >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pinion Flange Runout Measurement: Notes

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Special Tool 

J 8001 Dial Indicator Set, or equivalent 

J 23409 Dial Indicator Extension, or equivalent 

J 35819 Flange Runout Gauge 

NOTE: This measurement procedure is intended to measure drive axle pinion flanges with 1-piece U-joint yokes only, not bolt-on yokes.

If equipped with a system balanced flange, use the following procedure, System Balanced Flange. If equipped with a non-system balanced flange, use the second procedure, Non-System Balanced Flange.

scientia non olet · About LEMON Manuals