Component Testing
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Windshield Wiper Washer Switch
- With the WASH switch in the open position, test for infinite resistance between the ground terminal D and the signal terminal B.
- If not the specified value, replace the windshield wiper washer switch.
- With the WASH switch in the closed position, test for less than 2 ohms of resistance between the ground terminal D and the signal terminal B.
- If greater than the specified range, replace the windshield wiper washer switch.
Washer Pump
- Ignition OFF, disconnect the harness connector at the washer pump.
- Install a 10A fused jumper wire between the control terminal 2 and 12 volts. Install a jumper wire between the ground terminal 1 and ground.
- Verify the washer pump is activated.
- If the washer pump does not activate, replace the washer pump.