LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 1987 >> Samurai Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Lighting Systems) >> Diagnostic Information and Procedures >> Low and High Beams Headlamps Inoperative >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Multifunction/Headlamp Switch Circuit Testing 

  1. Ignition OFF, disconnect the harness connector at the headlamp switch.
  2. Test for less than 1 Ω of resistance between the ground circuit and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Install a 3-amp fused jumper wire between the signal circuit and ground. Verify the headlamps are ON.
    • If the headlamps are not ON, test the signal circuit of the headlamp switch for a short to voltage or an open/high resistance.
  4. If all circuits test normal, test or replace the headlamp switch.
scientia non olet · About LEMON Manuals