Removal Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Disconnecting Engine Wiring Harness Electrical Connector From Bank 2 Knock Sensor

Courtesy of SUZUKI OF AMERICA CORP.

Raise and suitably support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
Disconnect the engine wiring harness electrical connector (2) from the bank 2 knock sensor.

Fig 2: Identifying Knock Sensor & Bolt (1 Of 2)
Courtesy of SUZUKI OF AMERICA CORP.
Loosen the knock sensor bolt and remove the knock sensor.