MULTIVIEW Control Module

Install the multiview control assembly.
Install the center information display assembly. Ref. to ENTERTAINMENT & MONITORING>COCKPIT DISPLAY>ASSEMBLY .
Install the grille ventilation assembly center. Ref. to AIR CONDITIONER>AIR VENT GRILLE>INSTALLATION>CENTER GRILLE ASSEMBLY .
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
When the multiview control assembly has been replaced, perform the following procedures.
- Except for 4-camera model
  1. Using the Subaru Select Monitor, select [Carrying over Calibration data when replacing the Camera ECU] in [Work Support] of [Front & Side Camera/Multi View Monitor]. Ref. to COMMON (DIAGNOSTICS)>CUSTOMIZE>OPERATION > SAVE SETTINGS / READ SETTINGS
- 4-camera model
  1. Turn the ignition switch from OFF to ON, and keep this position for 2 seconds before turning the ignition switch to OFF. Turn the ignition switch to ON again.
  2. Using Subaru Select Monitor, select [Carrying over Calibration data when replacing the Camera ECU] in [Work Support] of [Front&Side Camera/Multi View Monitor], and perform the operation according to the display screen. Ref to 360-DEGREE SURROUND VIEW MONITOR/MULTI VIEW MONITOR (DIAGNOSTICS)>WORK SUPPORT
    NOTE: Data transfer is a procedure to write the automatically backed up calibration data of each camera in a new multiview control assembly.
  3. Read the [Front&Side Camera/Multi View Monitor] customizing information. Ref. to COMMON (DIAGNOSTICS)>CUSTOMIZE>OPERATION > SAVE SETTINGS / READ SETTINGS