Inspection Mode 4

Diagnostic procedure:

1. Check that the battery voltage is 12 V or more and fuel remains approx. half [20 - 40 L (5.3 - 10.6 US gal, 4.4 - 8.8 Imp gal)].
2. Perform the clear memory for «Keyless Access with Push Button Start» using the Subaru Select Monitor. Refer to KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)>CLEAR MEMORY .
3. Read the DTC of «Keyless Access with Push Button Start» using Subaru Select Monitor and check that the DTC is not displayed. Refer to KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .
   NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs. After solving the DTC, repeat from step  1.
4. Drive for 20 seconds or more at a vehicle speed of 25 km/h (15.5 MPH) or more.
5. Read the DTC of «Keyless Access with Push Button Start» using Subaru Select Monitor and check that the DTC is not displayed. Refer to KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .