VDC Control Module And Hydraulic Control Unit (VDCCM And H/U): Installation

CAUTION:

When installing the VDC control module and H/U to the VDC control module and H/U bracket, make sure that there is no oil adhered to the bolts and the threads of VDC control module and H/U. If the oil is adhered, degrease it carefully before tightening.
Connect the VDC control module and H/U connector securely.

Install the bracket COMPL hydraulic unit VDC and the hydraulic unit assembly VDC.
1. Attach the bracket COMPL hydraulic unit VDC.
  Tightening torque:
  
  33 N.m (3.4 kgf-m, 24.3 ft-lb)
2. Install the bracket hydraulic unit adapter to the hydraulic unit assembly VDC.
  Tightening torque:
  
  27 N.m (2.8 kgf-m, 19.9 ft-lb)
3. Install the hydraulic unit sub assembly to the bracket COMPL hydraulic unit VDC.
  Tightening torque:
  
  7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
4. Connect the hydraulic unit assembly VDC connector.
5. Install the pipe assembly front ABS using a flare nut wrench.
  Tightening torque:
  
  Refer to "COMPONENT" of "General Description" for the tightening torque. Ref. to BRAKE>GENERAL DESCRIPTION>COMPONENT>FRONT BRAKE PIPES AND HOSES .
Install the air intake boot.
- H4DO model: Ref. to INTAKE (INDUCTION) (H4DO)>AIR INTAKE BOOT>INSTALLATION .
- H4DOTC model: Ref. to INTAKE (INDUCTION) (H4DOTC)>AIR INTAKE BOOT>INSTALLATION .
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Bleed air from the brake system. Ref. to BRAKE>AIR BLEEDING>PROCEDURE .
Perform parameter confirmation, selection, and registration.
NOTE:
- When the VDC control module and H/U is replaced with a new part, be sure to perform the parameter selection/registration.
- When the registration has not been performed, the DTC code [SELECTED PARAMETER] is detected together with the ABS/EBD/VDC warning light illumination.
1. Check that the applied model and grade of the relevant vehicle are included. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM and H/U)>MAINTENANCE MODE>VDCCM PARAMETER CHECK .
2. If the applied model and grade of the target vehicle are not included, perform "parameter selection and registration". Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM and H/U)>MAINTENANCE MODE>VDCCM PARAMETER SELECTION .
Perform "VDC sensor midpoint setting mode". Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM and H/U)>ADJUSTMENT>VDC SENSOR MIDPOINT SETTING MODE .