Power Rear Gate Position Cannot Be Memorized

NOTE: Before performing diagnosis, initialize the power rear gate system by opening the power rear gate in manual operation, and then operating the power rear gate auto closer in the partially latched state.

CHECK DTC .
Read the DTC of [Power Rear Gate] using the Subaru Select Monitor. Ref. to Power Rear Gate (Diagnostics)>Diagnostic Trouble Code (DTC) .

Are any DTCs displayed?

Yes: Perform the diagnosis for the displayed DTCs.

No: Go to 2 .
CHECK MEMORY HEIGHT SW .
Is the memory height SW ON?

Yes: Go to 3 .

No: Set the memory height SW to ON.
CHECK EACH SW .
Perform inspections described in "POWER REAR GATE INNER SW DOES NOT FUNCTION" and "MEMORY HEIGHT SW DOES NOT FUNCTION". Ref. to POWER REAR GATE (DIAGNOSTICS)>DIAGNOSTICS WITH PHENOMENON>INSPECTION>POWER REAR GATE INNER SW DOES NOT WORK . Ref. to POWER REAR GATE (DIAGNOSTICS)>DIAGNOSTICS WITH PHENOMENON>INSPECTION>MEMORY HEIGHT SW DOES NOT FUNCTION .

Is the check result OK?

Yes: Replace Power rear gate control module. Ref. to POWER REAR GATE SYSTEM>POWER REAR GATE CONTROL MODULE .

No: Repair it according to each inspection.