LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2019 >> Outback 2.5i >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Lubrication System (3.6L)) >> Oil Pressure Switch >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Oil Pressure Switch: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Apply liquid gasket to the oil pressure switch threads.

    Liquid gasket: 

    THREE BOND 1324 (Part No. 004403042) or equivalent

    G10264242Courtesy of SUBARU OF AMERICA, INC.
  2. Install the oil pressure switch to the oil pan upper.

    Tightening torque: 

    25 N.m (2.5 kgf-m, 18.4 ft-lb)

  3. Connect the terminal to the oil pressure switch.
  4. Install the undercover. Ref. to EXTERIOR/INTERIOR TRIM>FRONT UNDER COVER>INSTALLATION .
  5. Lower the vehicle.
  6. Fill engine oil. Ref. to LUBRICATION (H6DO)>Engine Oil>REPLACEMENT .
  7. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About LEMON Manuals